光纤基底TiNi形状记忆合金薄膜制备工艺

将TiNi基记忆合金薄膜与光纤相结合可制成智能化、集成化且成本经济的微机电系统和微传感器件.本文采用磁控溅射法在二氧化硅光纤基底上制备TiNi记忆合金薄膜,系统讨论了溅射工艺参数以及后续退火处理对薄膜质量的影响.采用自研制光纤镀膜掩膜装置在直径为125μm的光纤圆周表面上形成均匀薄膜.实验表明:在靶基距、背底真空度、Ar气流量和溅射时间一定的条件下,溅射功率存在最佳值;溅射压强较大时,薄膜沉积速率较低,但薄膜表面粗糙度较小.进行退火处理后,薄膜形成较良好的晶体结构,Ti_49.09Ni_50.91薄膜中马氏体B19′相和奥氏体B2相共存,但以B19′为主.根据本文研究结果,在玻璃光纤基底上制备高质量的TiNi基记忆合金薄膜是可实现的,本工作为下一步研制微机电系统和微型传感器做了基础准备.     

Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost. We present a laterally coupled grating with slots. The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process. Moreover, the grating height in this structure can be decreased to lower the aspect ratio significantly, which is advantageous over the conventional laterally coupled ridge waveguide gratings. The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions. It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength; narrow slots (100 nm and 300 nm) and wide ridge (2 μm-4 μm) promote the stability of grating coupling coefficient and device performance. It is important to note that the grating bottom should be fabricated precisely. The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.     

强度解调型光纤光栅温度传感实验

光纤光栅在工程上应用广泛,但由于存在解调系统复杂、成本高,尤其是需要使用光纤光谱仪等波长解调仪器,使得光纤光栅很难走入本科教学的实验课堂.本文提出了一种基于窄线宽DFB激光器的强度解调方案,极大地简化了光纤光栅传感器的解调系统,完全满足较高分辨率和实时检测的系统要求.合理安排的温度传感实验可以非常直观地展示光纤光栅的线性传感性能,使得工程化的光纤光栅传感技术轻松走进本科教学课堂,具有极高的推广和应用潜力.     

光子晶体光纤温度压力传感器

提出了一种在高温环境下同时测量温度和气压的光子晶体光纤温度压力传感器.在普通单模光纤和光子晶体光纤之间熔接一段空心光纤构成干涉结构.空心光纤段构成非本征法布里-珀罗干涉仪,利用光子晶体光纤的微孔与外界相通,通过气体折射率变化来测量环境中的气压变化;光子晶体光纤段构成本征法布里-珀罗干涉仪,利用热膨胀效应和热光效应来测量环境中的温度.传感器的解调通过自制的白光干涉解调仪实现,实验通过测量腔长得到被测环境的温度和气压.在不同温度和气压环境下,对腔长分别为306μm和1535μm的温度压力光纤传感器进行连续测量.实验结果表明,传感器能够在28~800℃的温度下和0~10 MPa的气压下稳定工作,测量范围内温度灵敏度可达17.4 nm/℃,压力灵敏度随温度增加而降低,在28℃时可达1460.5 nm/MPa.     

油-气-水三相流超声传感器持气率测量*

为探索油-气-水三相流持气率测量难题,该文开展了脉冲透射式超声传感器持气率测量动态实验研究。首先,利用超声传感器与光纤传感器组合,测取了油-气-水三相流中段塞流、混状流、泡状流的响应信号;其次,提取了超声脉冲信号的最大值序列来反映不同流型时超声传感器响应特性,同时,借助双头光纤传感器与相关测速法,计算得到了流体中气泡弦长序列;最后,结合流型与泡径信息,利用超声传感器测量了不同流型下持气率,并分析了不同流型持气率预测的误差来源,为其他油-气-水三相流持气率测量传感器设计提供了借鉴。     

Optomechanical-organized multipulse dynamics in ultrafast fiber laser

A novel organized multipulse pattern and its birth dynamics under strong optomechanical effect in microfiber-assisted ultrafast fiber laser are investigated in this work. The background pulses are observed to obviously exhibit selectively amplifying self-organized process of evolving into quasi-stable equidistant clusters. The radio frequency spectrum of the multipulse pattern displays a harmonic mode-locking-like behavior with a repetition rate of 2.0138 GHz, corresponding to the frequency of torsional-radial (TR_2m) acoustic mode in microfiber. The results show the evidence of optomechanical effect in dominating the birth dynamics and pattern of multipulse.     

The single-polarization filter composed of gold-coated photonic crystal fiber

A single-polarization filter comprising a gold-coated photonic crystal fiber based on surface plasmon resonance is designed and investigated. The pattern matching and coupled polarization characteristics analyzed by the full-vector finite element method (FEM) and losses at 1,540 nm are achieved to 1,016.01739 dB/cm (x-pol core mode) and 33.81917 dB/cm (y-pol core mode). The crosstalk (CT) value of the 1,540 nm band is ?853.12653 dB for fiber length $L=1,000\mathrm{\mu }\text{m}$ and the bandwidth is 850 nm. The working wavelength of the filter ranges from 1,280 nm to 1,540 nm by varying the diameter of outer air holes ($d_1$), the diameter of inner air holes ($d_4$), the metal film thickness (t), as well as the liquid refractive index (n).     

Design of diamond-shape photonic crystal fiber polarization filter based on surface plasma resonance effect

A novel plasmonic polarization filter based on the diamond-shape photonic crystal fiber(PCF) is proposed. The resonant coupling characteristics of the PCF polarization filter are investigated by the full-vector finite-element method. By optimizing the geometric parameters of the PCF, when the fiber length is 5 mm, the polarization filter has a bandwidth of 990 nm and an extinction ratio(ER) of lower than -20 dB. Moreover, a single wavelength polarization filter can also be achieved, along with an ER of -279.78 dB at wavelength 1.55 μm. It is believed that the proposed PCF polarization filter will be very useful in laser and optical communication systems.     

基于非线性光纤环形镜的少模脉冲幅度调制再生器

随着网络带宽需求的快速增加,波分复用系统的容量已接近非线性香农极限.为了适应未来网络的发展,空分复用技术引起了越来越多的关注.本文首次提出基于少模非线性光纤环形镜(FM-NOLM)的脉冲幅度调制(PAM)全光再生器,描述了其工作原理和具体设计过程.采用COMSOL软件对组成FM-NOLM的硫化物高非线性光纤进行了模式特性仿真.以LP01,LP11,LP21三个光纤模式为例,确定了再生器的参数,计算出每个模式的功率转移函数曲线.仿真分析了该少模PAM-4全光再生器的噪声抑制(NRR)性能,并与单模情形进行了比较.研究表明,1)对于每个空间模式的PAM信号,所有再生电平具有一致的功率转移性能;2)当输入信噪比(SNR)约大于20 dB时,三种模式的噪声抑制比均可超过3 dB,并随着输入信噪比线性增加,其斜率约为1.2;3)在相同输入SNR条件下,三种模式的噪声抑制比相差不大,不超过1.1 dB.为了说明再生器的再生性能,当输入SNR为25 dB时,我们还给出了再生前后PAM-4信号的功率分布直方图.与现有的再生方案相比,本文方案的均匀多电平再生转移性能,使其更适合高频谱效率的长距空分复用系统和任意电平数的PAM信号再生.此外,该方案也能够扩展到波长域,有效提高光通信系统的传输容量.